New silicone design! The silicone ring at the top flawlessly supports most caps! The holder also has a silicone drip pad to help make the cleaning process a little easier.
If you have any concerns about your cap fitting, just send us a message!
Over 2 and a half years of experience with 3D printing have allowed me to dial in the settings on my printer to an absolutely perfect level. No visual flaws or defects here. The professional quality of our prints is bound to impress you and open your mind to the world of 3D printing.
While bringing new innovations to the world is a passion of ours, so is helping the environment. This carb cap stand is manufactured using a corn-based bio-plastic known as PLA (Poly Lactic Acid). PLA is not only a renewable resource, but its also “100% BIODEGRADABLE” which is something that almost no other plastics out there can say. So by buying our products, you can call yourself a proud supporter of a green company.
DIMENSIONS / SIZE
– The base is about 2.75″/70mm in diameter
– The height of holder is about 1″ /27mm
– The inside of diameter of the silicone ring is 23mm
– The outside diameter is 24mm
– ANY CARB CAP GREATER THAN 23mm WILL FIT!!!
-Carb cap not included
To maintain best the best quality for the longest time make sure to:
– Keep products out of direct sunlight
– Try and avoid storing in temperatures above 85 Degrees
– Do not pull on silicon pieces
-Use a clean paper towel with isopropyl alcohol to clean product when dirty.
– The Silicone Carb Cap Holder is safe to clean with rubbing alcohol, but don’t soak it for extended periods of time or it will affect the color.